If you are planning on carrying out work to your plumbing system, you should at least have the following tools and equipment.
A must to keep radiators running efficiently by allowing air trapped in the system to escape.
Curing a dripping tap is often as simple as replacing a worn washer.
For a tight seal, ensure washers in joints are up to scratch.
Wrap this tape around the end of pipework prior to inserting it into joints and valves to ensure a really good seal.
Keep pipes tidy, supported and reduce water hammer.
Cut a copper pipe to the correct length with a good, clean edge.
To evenly and smoothly bend pipes so that they travel round bends of up to 90 degrees.
To add new appliances and fixtures to your plumbing system, copper pipe of the correct size is required to carry the water supply to and from it.
To avoid completely draining your plumbing system, use a freezing kit to solidify water in the incoming pipework and allow yourself upto 30 minutes to do the job.
For use with soldering connections and a soldering torch.
Easily applied to joint areas prior to soldering. Designed specifically for the soldering of copper plumbing systems, although a range of metals/alloys can be jointed with it.
For use with soldering connections and solder wire.
Site Pages
Featured Articles